I ordered a new Denso Direct-Fit O2 sensor to fix my p1166-67 codes, so I was expecting a primary.
After the impulse buy at a $50 discount(Still overpayed looking back) and screwing in the new sensor, I notice the connectors are the same! Looking back I see this was a huge NOOB mistake!
Can I do something to make it work, or should I just send it back? The sensor is just screwed in hangin' out for rn
Part No. 234-4360
After the impulse buy at a $50 discount(Still overpayed looking back) and screwing in the new sensor, I notice the connectors are the same! Looking back I see this was a huge NOOB mistake!
Can I do something to make it work, or should I just send it back? The sensor is just screwed in hangin' out for rn
Part No. 234-4360
Wrong O2 Sensor connector, send back or splice?
0 commentaires:
Enregistrer un commentaire