Hey guys, so I'm trying to figure out the schematics on how to wire a flash/strobe module for a third (fourth) CRV brake light.
I've read a couple of threads but either pictures are down or they're a bit unclear to me, so I'd like to revive them and possibly make a picture orientated DIY.
Things I've figured out how to wire:
-CRV light stays off and only lights up to brake.
-CRV light constantly stays on as a rear fog light (not affiliated to brakes)
I believe these CRV LED Brake lights are not dual-function so they don't have a dim setting, then light up even brighter like a regular brake bulb.
However, I'm a bit confused how to keep constant power then flash when there are only 2 wires coming from the relay.
Black - Ground
Red - Power
Grey (white) - Brake Signal
TL;DR - How do I wire this to keep a constant solid light, then flash when brake pedal is depressed?
I've read a couple of threads but either pictures are down or they're a bit unclear to me, so I'd like to revive them and possibly make a picture orientated DIY.
Things I've figured out how to wire:
-CRV light stays off and only lights up to brake.
-CRV light constantly stays on as a rear fog light (not affiliated to brakes)
I believe these CRV LED Brake lights are not dual-function so they don't have a dim setting, then light up even brighter like a regular brake bulb.
However, I'm a bit confused how to keep constant power then flash when there are only 2 wires coming from the relay.
Black - Ground
Red - Power
Grey (white) - Brake Signal
TL;DR - How do I wire this to keep a constant solid light, then flash when brake pedal is depressed?
Flash/Strobe Module for Brake light
0 commentaires:
Enregistrer un commentaire