Thought I would post up an install guide for the TypeR brake duct covers since i had taken pictures of the process while i did it a few months ago.
Tools:
Cutting tool (only for 1st Gen models)
Screwdriver
Hardware needed: Make sure its stainless steel
Step 1: Remove your front bumper
Step 2: Cut out the Oem covers if you have a 1st Gen Rsx (2nd Gen the covers pop out)
Step 3: The holes for the screws come none threaded so before you break anything take the time to drive screws into each of the holes (will make it a lot easier when you go to install)
Step 4: Clip the outer covers into place
Step 5: Screw everything into place and tighten it all up.
Step 6: reinstall front bumper and enjoy being different :thumbsup:
Tools:
Cutting tool (only for 1st Gen models)
Screwdriver
Hardware needed: Make sure its stainless steel
Step 1: Remove your front bumper
Step 2: Cut out the Oem covers if you have a 1st Gen Rsx (2nd Gen the covers pop out)
Step 3: The holes for the screws come none threaded so before you break anything take the time to drive screws into each of the holes (will make it a lot easier when you go to install)
Step 4: Clip the outer covers into place
Step 5: Screw everything into place and tighten it all up.
Step 6: reinstall front bumper and enjoy being different :thumbsup:
TypeR Brake duct cover install
0 commentaires:
Enregistrer un commentaire